MAXON SD9 DISTORSORE

155,00

Esaurito

COD: MAX-SD-9S Categorie: ,

Descrizione

Input signal goes through a simple High-Pass filter into a transistor that’s set up as an emitter/follower (high input impedance – low output impedance).  After this it’s into an Op Amp stage designed to give a gain range of 67 to 567and a Low-Pass Filter with a corner frequency of approximately 1540 Hz.

From here it’s on to a set of opposing-direction diodes to ground and a tone control that is reminiscent of the Boss DS-1 (kind of a Big Muff dual High and Low cut – ending up with a mid scoop that has a high frequency limiting resistor with corner frequencies of 867Hz and 234Hz respectively).

The SD-9’s dual diodes to ground give a crunchier, chewier distortion than the popular 808-style “diodes in feedback loop” configuration.  Likewise, the SD-9’s mid scoop is practically the antithesis of the 808’s infamous mid hump.

After the tone control section it’s through to a volume control and into another E/F transistor to provide a low impedance output and then on to the true bypass switch.

The SD-9 features Mechanical True Bypass switching via a Fujisoku 4PDT switch – Input is switched to ground when bypassed.

Input Impedance: 500K Ohms

Input Jack: 1/4 inch standard phone jack

Output Impedance: 10K Ohms

Output Jack: 1/4 inch standard phone jack

Output: 1

Equivalent Input Noise: -114 dB or less (input shorted IHF-A weighted)

Maximum Output Level: 0 dBm

Maximum Gain: +42 dB (at 2.0 KHz)

Controls: Distortion, Tone, Level

Switch: Normal/Effect (true bypass configuration)

Power Supply: 9V Manganese dry cell battery (6F22) or special AC adaptor

Power Voltage: DC9 V (Battery) / DC10 V (AC-adaptor)

Current Consumption: 6 mA (9 V) / 7 mA (10 V)

AC Adaptor: AC210N (option) Input: AC120V Output: DC9V/200 mA Center – / Sleeve +)

Dimensions (whole): 74 mm (W) x 124 mm (D) x 54 mm (H)

Weight: 580 g

Warranty Card: x 1

User’s Manual: x 1

Informazioni aggiuntive

Marca per ecommerce

MAXON-EFFETTI